Cast as a blank – a step by step design
— 8 May 2020Academic experience led to a return to the topic of developing a blank design as a casting. The selection
Continue Reading ...
-
-
Construction drawing and technology. How to read?
— 26 April 2019During the design classes I noticed that the analysis of the construction drawing in terms of technology
Continue Reading ... -
Shaft technology – technological process – operation 30
— 16 January 2019Operation 30 is the penultimate operation of shaping the workpiece. The general technological process
Continue Reading ... -
Shaft technology – technological process – operation 20
— 6 January 2019Shaft technology also means machining holes, mainly axial but also lateral holes. In the case of this
Continue Reading ... -
Shaft technology – technological process – operation 10
— 28 December 2018Operation 10 as part of each technological process is so-called first operation. The convention of numbering
Continue Reading ... -
Shaft technology – technological process
— 9 December 2018The shaft technology is a very popular subject in the process of technological education. There is an
Continue Reading ... -
Workpiece for piece production – 3D print
— 16 July 2018The workpiece for piece production so far has been characterized by the simplicity of the design and
Continue Reading ... -
Milling – selection of machining parameters
— 10 January 2018Milling in relation to turning is characterized by much greater variation. The following are the basic
Continue Reading ... -
Turning – selection of machining parameters
— 7 November 2017Machining parameters, including turning parameters (fig. 1), are a challenge for every technologist.
Continue Reading ... -
Workpiece as a casting in series production
— 26 March 2017The blank (workpiece) in the form of a cast is economically justified in the case of series production
Continue Reading ...
