Shaft technology – technological process – operation 30
— 16 January 2019Operation 30 is the penultimate operation of shaping the workpiece. The general technological process
Continue Reading ...Operation 30 is the penultimate operation of shaping the workpiece. The general technological process
Continue Reading ...Shaft technology also means machining holes, mainly axial but also lateral holes. In the case of this
Continue Reading ...Operation 10 as part of each technological process is so-called first operation. The convention of numbering
Continue Reading ...The shaft technology is a very popular subject in the process of technological education. There is an
Continue Reading ...Previous post in the series: Technology of the sleeve, part 5 – boring. Technological operation
Continue Reading ...Previous post from the series: Technological process of sleeve, part 4 – drilling. Technological
Continue Reading ...Previous post from the series: Technological process of sleeve, part 3. Operation 30 – drilling
Continue Reading ...Previous entry in the series: Technological process of sleeve, part 2 Operation 20 Figure 1 shows a technological
Continue Reading ...Previous post in the series: Technological process of sleeve, part 1. In the entry Sleeve – framework
Continue Reading ...Technological process of sleeve – a series of entries under the technological preparation of the
Continue Reading ...