Shaft technology – technological process – operation 30
— 16 January 2019Operation 30 is the penultimate operation of shaping the workpiece. The general technological process
Continue Reading ...
-
-
Shaft technology – technological process – operation 20
— 6 January 2019Shaft technology also means machining holes, mainly axial but also lateral holes. In the case of this
Continue Reading ... -
Shaft technology – technological process – operation 10
— 28 December 2018Operation 10 as part of each technological process is so-called first operation. The convention of numbering
Continue Reading ... -
Shaft technology – technological process
— 9 December 2018The shaft technology is a very popular subject in the process of technological education. There is an
Continue Reading ... -
Technological process of sleeve, part 1
— 14 June 2016Technological process of sleeve – a series of entries under the technological preparation of the
Continue Reading ... -
Norm time in the technological process
— 22 February 2016The standard of technological times (norm time) – determined at the end of the traditionally developed
Continue Reading ...
