Electrical discharge machining (EDM and WEDM)
— 14 October 2019The use of mechanical treatments is difficult for economic and / or technological reasons. As a consequence,
Continue Reading ...
-
-
Determining the machining time – main time
— 28 June 2019The main time (tg – main machine time or main manual time) is a component of the standard of technological
Continue Reading ... -
Construction drawing and technology. How to read?
— 26 April 2019During the design classes I noticed that the analysis of the construction drawing in terms of technology
Continue Reading ... -
Shaft technology – technological process – operation 30
— 16 January 2019Operation 30 is the penultimate operation of shaping the workpiece. The general technological process
Continue Reading ... -
Shaft technology – technological process – operation 20
— 6 January 2019Shaft technology also means machining holes, mainly axial but also lateral holes. In the case of this
Continue Reading ... -
Shaft technology – technological process – operation 10
— 28 December 2018Operation 10 as part of each technological process is so-called first operation. The convention of numbering
Continue Reading ... -
Shaft technology – technological process
— 9 December 2018The shaft technology is a very popular subject in the process of technological education. There is an
Continue Reading ... -
Milling – selection of machining parameters
— 10 January 2018Milling in relation to turning is characterized by much greater variation. The following are the basic
Continue Reading ... -
Turning – selection of machining parameters
— 7 November 2017Machining parameters, including turning parameters (fig. 1), are a challenge for every technologist.
Continue Reading ... -
Technological process of sleeve, part 1
— 14 June 2016Technological process of sleeve – a series of entries under the technological preparation of the
Continue Reading ...
