Technological process route
— 7 September 2020The technological process route is also referred to as the production route, in other words, a work plan,
Continue Reading ...
-
-
Cast as a blank – a step by step design
— 8 May 2020Academic experience led to a return to the topic of developing a blank design as a casting. The selection
Continue Reading ... -
Electrical discharge machining (EDM and WEDM)
— 14 October 2019The use of mechanical treatments is difficult for economic and / or technological reasons. As a consequence,
Continue Reading ... -
Construction drawing and technology. How to read?
— 26 April 2019During the design classes I noticed that the analysis of the construction drawing in terms of technology
Continue Reading ... -
Shaft technology – technological process – operation 30
— 16 January 2019Operation 30 is the penultimate operation of shaping the workpiece. The general technological process
Continue Reading ... -
Shaft technology – technological process – operation 20
— 6 January 2019Shaft technology also means machining holes, mainly axial but also lateral holes. In the case of this
Continue Reading ... -
Shaft technology – technological process – operation 10
— 28 December 2018Operation 10 as part of each technological process is so-called first operation. The convention of numbering
Continue Reading ... -
Shaft technology – technological process
— 9 December 2018The shaft technology is a very popular subject in the process of technological education. There is an
Continue Reading ... -
Milling – selection of machining parameters
— 10 January 2018Milling in relation to turning is characterized by much greater variation. The following are the basic
Continue Reading ... -
Technological process of the sleeve, part 6 – grinding
— 6 November 2016Previous post in the series: Technology of the sleeve, part 5 – boring. Technological operation
Continue Reading ...
